APW Wyott M-91 Operations Instructions download pdf (Page 4)

NOTICE: The unit, when installed, must be electrically grounded and comply with local

codes, or, in the absence of local codes, with the national electrical code ANSI/NFPA70-

latest edition. Canadian installation must comply with CSA-STANDARD C.22.2 Number 0

M1982 General Requirements-Canadian Electrical Code Part II, 109-M1981-

Commercial CookingAppliances.

NOTICE: Local codes regarding installation vary greatly from one area to another. The

National Fire Protection Association, Inc., states in its NFPA96 latest edition that local

codes are “Authority Having Jurisdiction” when it comes to requirement for installation of

equipment. Therefore, installation should comply with all local codes.

WARNING: Do not obstruct either the air inlet (underneath unit) or the ventilation air (back

of unit). Provisions must be provided to provide an adequate air supply to the griddle.

WARNING: Keep the appliance free & clear of all combustible substances. If gas odor is

detected at any time, immediately shut unit down at the main shutoff valve. Do not permit

any open flames in the area of the appliance. Immediately contact an authorized Service

Agency or your local Gas Supplier for service.

SPECIFICATIONS AND DIMENSIONS

GGT-24 24 (610) 26 (661) 17-3/4(451) 2 25,000/7.3 50,000/14.6 6/10(15/25)

GGT-36 36 (915) 26 (661) 17-3/4(451) 3 37,500/11 75,000/22 6/10(15/25)

GGT-48 48 (1220) 26 (661) 17-3/4(451) 4 25,000/7.3 100,000/29.3 6/10(15/25)

GGM-24 24 (610) 26 (661) 16-3/4(426) 2 25,000/7.3 50,000/14.6 6/10(15/25)

GGM-36 36 (915) 26 (661) 16-3/4(426) 3 37,500/11 75,000/22 6/10(15/25)

GGM-48 48 (1220) 26 (661) 16-3/4(426) 4 25,000/7.3 100,000/29.3 6/10(15/25)

DEPTH

IN. (MM)

DEPTH

IN. (MM)

GGT-24 and GGM-24 23 13/16”/ 605 19 1/2”/ 496

GGT-36 and GGM-36 35 13/16”/ 910 19 1/2”/ 496

GGT-48 and GGM-48 47 13/16”/ 1215 19 1/2”/ 496

GENERAL INSTALLATION INSTRUCTIONS

Ensure gas supply and gas type, as shown on unit nameplate agree.

Unit installation must conform with the National Fuel Gas Code, ANSI Z223.1-1996, the National Gas

Installation Code, CAN/CGA-B149.1, or the Propane Installation Code, CAN/CGA-B149.2 as applicable

and in accordance with local codes.

Screw legs into the permanently fastened nuts on the four corners of the unit and tighten by hand. Level the

unit by turning the adjustment screw at the bottom of each leg. Do not slide unit with legs mounted, lift if

necessary to move unit.

Pipe threading compound must be resistant to the action of liquefied petroleum gases.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

APW Wyott M-91 Operations Instructions Page 4